STEP 1

Remove original “stock” visor. Always remember….STOCK SUCKS!

rig_skirts01

STEP 2

Original visor is removed, exposing factory mounting brackets. Keep the 4 bolts that hold the “ends” of the visor to the cab, as we will be re-using them.

rig_skirts02

STEP 3

Cover the glass to prevent “sparks” from damaging the windshield. Use a “die grinder” and “cut off wheel” to grind off the heads of the huck bolts that hold the factory brackets to the roof. Remove the brackets.

rig_skirts03

Rubber well nuts (supplied)

rig_skirts04

STEP 4

Drill the “huck rivet” holes in the roof cap out to ½” diameter. Apply a small amount of silicone to the outer diameter of well nut and insert into ½” holes.

rig_skirts05

STEP 5

Mount the supplied mounting brackets in place. Get the bolts a little tighter than “snug” but not “crazy tight”!

rig_skirts06

All “new” brackets installed.

rig_skirts07

STEP 6

Bolt visor panels on. Install the outer “end” bolts first. Leave loose – do not tighten yet.

rig_skirts08

STEP 7

Install the center bolts next. Then install the bolts in the outer brackets. Once all bolts are in, align the visor and tighten all bolts.

rig_skirts09

STEP 8

Remove the protective coating, clean with Windex and soft cotton cloth.

rig_skirts10

Now your rig has a whole new attitude! TRUCK IT UP!

rig_skirts11